KeySleeve Amethyst

• Fits Inhale Club aluminium nasal inhalers (16.6 mm body)
• About 27 mm across, 58 mm tall, under 20 g
• Inhaler drops in dome first and is held by spring fingers inside the wall
• Rim sits on the cap seam, so the base stays free to unscrew and refill
• 15 mm O-ring through the wall, with a swivel lobster clasp
• Spline: 28 square-cut ribs. Flute: eight wide coves

3D printed in Australia in plant-based PLA. Wipe clean with a damp cloth. PLA starts to soften at around 55 to 60 °C, so keep it off a hot dashboard or windowsill in summer.

A printed sleeve for your Inhale Club nasal inhaler, with a steel split ring cast into the wall so it can live on your keys. The inhaler drops in dome first and is held by spring fingers inside the wall, so you can unscrew the base one-handed while the sleeve holds the cap. Slide it out whenever you want it bare.

Two styles: Spline (28 square-cut ribs, like a splined shaft) and Flute (eight wide coves, like a screwdriver handle). This is Amethyst, a soft mid purple. Also in Charcoal, Rhodonite and Granite. Each one is 3D printed in Australia in plant-based PLA.

This first run is small. Once a colour is gone, it's gone until the next batch.

• Fits Inhale Club aluminium nasal inhalers (16.6 mm)
• About 27 mm across, 58 mm tall, under 20 g
• Rim sits on the cap seam, so the base stays free to unscrew
• Split ring included